CARGRAPHIC Piston and Liners Set
CARGRAPHIC FORGED Piston and Steel Liner Set
Conversion to 3,9l
104mm / 107mm spigot size 3894ccm
for
- Porsche 996 GT3/RS
- Porsche 996 GT3 Cup
- Porsche 997.1 GT3/RS
- Porsche 997.1 GT3 Cup
Conversion to 3,9l
104mm / 107mm spigot size 3894ccm
for
- Porsche 996 GT3/RS
- Porsche 996 GT3 Cup
- Porsche 997.1 GT3/RS
- Porsche 997.1 GT3 Cup
Price Net Export: 5.995,00 € / A8
Price incl. 19% German VAT: 7.134,05 €
Part No: CAR103GT390024
request article print article
Productdescription:
CARGRAPHIC FORGED Piston and Steel Liner set Conversion to 3,9l
Consisting of:
- 6 x Piston, 3xLH / 3xRH, forged, 22mm pin, 13:1 compression ratio, 418g / 518g.
- 6 x Steel liner Ø104mm bore, Ø107mm spigot direct fit no block modification required 3894ccm.
- 6 x piston ring sets
- 6 x Piston pin 22mm
- 12 x Circlips for piston pin
- Porsche 996 GT3/RS
- Porsche 996 GT3 Cup
- Porsche 997.1 GT3/RS
- Porsche 997.1 GT3 Cup
- Nikasil coated forged alloy barrels / steel liners for a perfect slide characteristic
- Optimized piston produced from special forgetool.
- Desaxes pin offset for LH / RH fitment. As a result of the desaxing, the piston changes the contact side already before TDC, when the compression pressure is only building up. This reduces piston wear and engine noise.
- Center of gravity and weight optimized using FEM-calculation.
- Special bridged version for optimal stability and longevity.
- Sophisticatedly milled treated, resulting in weight reduction
- Deeper valve pockets, Inlet big / Outlet small, to be used with high lift camshafts.
- Special piston rings to avoid oil consumption / blowby
- Also suitable for VarioCam Plus
- Most effective and efficient Power upgrade
- Perfectly matched high performance components
- Maximum power, torque and agility
- Developed and tested on RS-Tuning dyno
Benefit from our fitting service in our modern and hightech workshop. A team of qualified, experienced technicians fulfill all your needs with due skill, care and diligence.