1. 0
  2. 1
Previous Next
Show Program
back

CARGRAPHIC Piston and Liners Set

CARGRAPHIC FORGED Piston and Steel Liner Set
Conversion to 3,9l
104mm / 107mm spigot size 3894ccm
for
- Porsche 996 GT3/RS
- Porsche 996 GT3 Cup
- Porsche 997.1 GT3/RS
- Porsche 997.1 GT3 Cup

on request
Part No: CAR103GT3CUP3900C

request article print article

Productdescription:
CARGRAPHIC FORGED Piston and Steel Liner set Conversion to 3,9l

Consisting of:
  • 6 x Piston, 3xLH / 3xRH, forged, 22mm pin, 13:1 compression ratio, 418g / 518g.
  • 6 x Steel liner Ø104mm bore, Ø107mm spigot Slip in direct fit no block modification required 3894ccm.
  • 6 x piston ring sets
  • 6 x Piston pin 22mm
  • 12 x Circlips for piston pin
Fits for:
  • Porsche 996 GT3/RS
  • Porsche 996 GT3 Cup
  • Porsche 997.1 GT3/RS
  • Porsche 997.1 GT3 Cup
Features:
  • Nikasil coated steel liners for a perfect slide characteristic
  • Optimized piston produced from special forgetool.
  • Desaxes pin offset for LH / RH fitment. As a result of the desaxing, the piston changes the contact side already before TDC, when the compression pressure is only building up. This reduces piston wear and engine noise.
  • Center of gravity and weight optimized using FEM-calculation.
  • Special bridged version for optimal stability and longevity.
  • Sophisticatedly milled treated, resulting in weight reduction
  • Deeper valve pockets, Inlet big / Outlet small, to be used with high lift camshafts.
  • Special piston rings to avoid oil consumption / blowby
  • Also suitable for VarioCam Plus
  • Most effective and efficient Power upgrade
  • Perfectly matched high performance components
  • Maximum power, torque and agility
  • Developed and tested on RS-Tuning dyno
Fitting Service:
Benefit from our fitting service in our modern and hightech workshop. A team of qualified, experienced technicians fulfill all your needs with due skill, care and diligence.